An RS-25 engine burned for three minutes and 20 seconds at NASA’s Stennis Space Center in Mississippi on 18 November 2026. The test ended at its planned 200-second mark, according to NASA’s account. The engine, numbered 10001, was bolted into the Fred Haise Test Stand. It will stay on the ground. The point of running it was to collect evidence that NASA and engine contractor L3Harris Technologies can use on hardware intended for future Artemis missions.
That distinction matters when reading an announcement about a rocket engine. There is a difference between running a development article and clearing a particular flight engine for a particular launch. A development article gives engineers a chance to observe how a design behaves under selected conditions. A flight engine is an individual piece of hardware that has to be checked before it can be installed on a rocket. The November firing belonged to the development side of that work.
Why the same test engine keeps firing
Engine 10001 had already completed a longer run at Stennis on 21 October 2026. In its report on that firing, NASA said the engine ran for 500 seconds, roughly as long as the RS-25 engines fire during a Space Launch System launch. NASA also reported that the earlier test ran at the 111 percent power level. That is a value on the engine’s rating scale. It tells readers how NASA describes the operating condition, rather than giving a percentage of how much fuel was used.
The agency’s account of the November test gives its duration and purpose. It does not give the same level of detail about the engine’s operating conditions. A shorter firing can give engineers the observations they need for a different part of a programme. Without the test plan, the change in length alone says very little. Watch for an agency report that identifies a specific change in hardware, an operating condition or a result engineers can compare against an earlier test.
What a test stand lets engineers see
A launch vehicle has to leave the ground, steer and fly through changing conditions. Fixing an engine to a stand gives a test team a way to study it while keeping it in a known place. The crew can check measurements around the firing and inspect components after shutdown. As with a car taken to a workshop after a test drive, some useful evidence comes from what people find after the noise stops.
A photograph captures the fire and exhaust. It cannot show how a part wore, whether a sensor stayed within expectations or what the operator saw in the control room. Those details can matter more to the next test decision than the visual drama. A picture of a real firing is good documentary evidence of what took place at the stand. The engineering conclusions come from the measurements and inspections.
How the engine fits into Artemis
NASA’s Space Launch System uses four RS-25 engines. The agency says they can produce up to two million pounds of combined thrust. They are part of the rocket NASA plans to use to send astronauts aboard Orion on Artemis IV. In its 19 November announcement, NASA described that mission as a lunar landing planned for 2028, with a launch from Kennedy Space Center in Florida.
The November test gives readers a specific event to follow between launches. When a later firing is announced, compare the engine number, the duration and the stated purpose before drawing a connection. The same number usually points back to the same piece of test hardware. For more on international science and policy, browse The Popular Story’s World coverage.
There is one more useful detail in the announcement itself. NASA dated the photograph and firing to 18 November, while the report appeared the following day. Keeping those two dates straight makes it easier to follow updates from Stennis, particularly when the same engine appears in several images taken weeks apart.

